Improvement in the Thermomechanical Properties and Adhesion of Wood Fibers to the Polyamide 6 Matrix by Sequential Ball Milling Technique

The engineering thermoplastics industry has largely limited the use of natural fiber reinforcements due to their susceptibility to low-onset thermal degradation and water absorption. Therefore, in order to utilize these economically viable and environmentally friendly materials effectively through common composite fabrication methods such as hot pressing, safeguarding them from thermal degradation becomes essential. This work presents a viable industrially technique called sequential ball milling for processing unbleached softwood kraft pulp fibers (PF) with an engineering thermoplastics polyamide 6 (PA6) with high melting temperatures (>220 °C). An additional eco-friendly modification step that employs ball milling and cellulose nanocrystal (CNC) has been implemented in this study to enhance the mechanical properties of the composites. Special attention is given to fine-tuning key variables, such as milling duration and PF particle size, to produce optimal composites. Leveraging the ability of sequential ball milling to evenly distribute pulp fibers into PA6, a 160% increase in Young’s modulus was achieved with the incorporation of 30 wt % PF. Importantly, the introduction of a 5 wt % CNC modifying agent elevated Young’s modulus to 4.3 GPa, marking a 187% improvement over unmodified PA6. Diverse techniques, including rheological analyses, thermomechanical evaluations, morphological examinations, and assessments of moisture absorption, were utilized to validate the efficiency of the suggested processing approach and the modification phase.