Challenges in Contacting Metal–Polymer Current Collectors in Pouch Cells

Recent research focuses on replacing metal current collectors with metallized polymer foils. However, this introduces significant challenges during cell production, as manufacturing steps must be adapted. Currently, copper is used as the current collector on the anode side and aluminum on the cathode side. These current collectors are then joined within the cell with an arrester tab. This step, known as contacting, is carried out industrially in pouch cells using ultrasonic welding or laser beam welding. However, since the polymer foil is electrically insulating, the current contacting procedures cannot be directly transferred to the metal–polymer current collectors. In this work, ultrasonic welding, laser beam welding, and a mechanical contacting method are considered, and the challenges arising from the material properties are highlighted. The properties of the joints are discussed as a function of the number of foils and the coating thickness of the metallization. It is demonstrated that successful contacting by ultrasonic welding and mechanical clamping is possible, as both mechanical strength and electrical conductivity are ensured by the joint. Laser beam welding was unsuccessful. Additionally, the electrical resistance is one to two orders of magnitude higher than that of pure aluminum and copper foils, which necessitates further optimization. Furthermore, ultrasonic welding is limited to welding 16 foils or fewer. This does not match industrial requirements. Consequently, novel approaches for contacting metal–polymer current collectors are required.