Optimizing Performance of PVC Gel Actuators: Temperature Influence and Characterizations

PVC gels are in high demand for actuators, so choosing the optimal route for preparing PVC gel is crucial. In this study, PVC gel samples were prepared using polymer PVC, plasticizer Di-butyl adipate (DBA), and solvent tetrahydrofuran (THF) at temperatures ranging from 40°C to 70°C. The samples obtained at different temperatures were labeled as PVC40, PVC50, PVC60, and PVC70. Rheological properties of all PVC gel samples were analyzed, revealing, that the rheological behavior of the PVC70 gel sample differed significantly from the others due to THF evaporation at 70°C, resulting in inadequate PVC gel preparation. However, PVC40, PVC50, and PVC60 gel samples were chosen for further characterizations, including scanning electron microscopy (SEM), actuation, and mechanical properties evaluation. Moreover, a self-assembled setup was fabricated using electrodes and PVC gel to test the performance of the planar actuator. The maximum displacement of PVC60 was measured at approximately 0.74 mm, with a response time of 0.75 sec under an applied voltage of 1000V. It was observed that the homogeneity of the gel and the solubility of the raw materials, based on resin were influenced by the reaction temperature, suggesting that uniformity could be achieved through dipole-dipole interactions or hydrogen bonding between PVC and DBA (Cl-H…. O=C). Finally, our findings have the potential to contribute to the development of innovative PVC gel actuators.